AKOCREATION has previouly produced the widely popular 1/100 Powered GM Plastic Conversion and 1/100 Spartan GM Conversion. The resin conversion for the GM Cannon was highly anticipated.

The AKOCREATION GM Cannon Resin Conversion requires the MG RX78-2 (OYW) as a base kit for the resin parts.

Packaging:

The pieces came packed in the box below.

The Contents:

1. Coloured and very clear instruction manual
2. Metal Thrusters
3. Water slide GM decal sheets (Useable on 1/144 and 1/100)
4. The resin conversion parts

Casting:

Very crisp. However, there are some excess and thick resin flash which would need some care to be removed.

The back of the GM Leg.

Torso back panel

The straight gun barrel.

The head: Akocreation can use plastic for the mold instead of resin as the construction is very well casted for the joints and securing pegs.

Visor: You are better off sourcing for a Bandai CLEAR visor. Unless you start polishing this.

The back pack. Will need to be careful to remove the excess resin flash at the bottom.

Back Bottom Armour Panel.

Front Side Armour Panel.

Conclusion: I would personally like to see this as a plastic conversion instead of resin due to the very crisp mold AKOCREATION used as shown on the GM head. For me, this is highly recommended to build up your GM variants.